20V 4age- VVT Solenoid to head seal

Description

20V 4age- VVT Solenoid to head seal

The VVT solenoids as used on the 20V engines can develop a leak either internally or externally from between where they are fitted into the head. This outer seal is an O-ring that sits on the VVT solenoid itself. Suits all of the 20V 4age engine variants.

Installation

– Remove the VVT solenoid from the head.

– Remove old O-ring seal from the solenoid by either peeling it off or cutting it in half with a knife.

– Wipe down the slot.

– Slide this replacement seal over the end and into the slot.

– Use oil or grease to lightly coat the outside of the seal to stop binding. Not doing so may cause the seal to be damaged during the re-install.

– Refit the solenoid